PDA

View Full Version : My fuel pump set up


69coupe
19-03-2008, 08:19 AM
Mounted my fuel pump set up in the boot ready for the Big Block. Have run a seperate 1/2 inch pipe to the bottom of the tank leaving the original pick up and sender. Relay is activated from a toggle switch on the dash connecting the battery mounted in the boot via a fuse. A cut off switch will sit between the positive and starter motor
1/2 inch line then runs to a regulator and pressure gauge mounted on the inner guard to be set a around 6-7 LB
:D

SirGeo
20-03-2008, 09:32 AM
looks nice and neat.. but how loud is it in the cabin with it on? I know with my brothers old car, it was hard mounted to the back of the rear seat, and the noise level was excrutiating, especially if you were in the back....

69coupe
26-03-2008, 09:08 AM
looks nice and neat.. but how loud is it in the cabin with it on? I know with my brothers old car, it was hard mounted to the back of the rear seat, and the noise level was excrutiating, especially if you were in the back....

Sir Geo
Not to bad actually. The actual Holley pump is rubber mounted, apart from the usual Holley buzz is ok me. The exhaust noise will drown all :D anyway